ET51CE

**Process uses files found on shared drive at Technical Services\Customer Files\Disney\DCL - Disney Cruise Lines\Staging and Kitting Services\ET51CE**

Tablet Build

Installing the Tablet Case w/ the Expansion Back (SG-ET5X-8RCSE2-02 (Case) & ZBK-ET5X-8RH1-01 (Expansion Back))

This guide will help you install the Tablet Case and the Expansion Back. Please refer to the picture provided for visual guidance.

Installing the Rugged Case (SG-ET5X-8RCSE2-02)

Installing the Expansion Back (ZBK-ET5X-8RH1-01)

Important: If your device has two rubber gaskets, please remove both. Refer to the "Tablet (Rubber Gasket Inserted)" and the "Tablet (Rubber Gasket Removed)" pictures below.

Additional Picture References

Installation is complete. The result should look like the "Tablet (Full Install)" picture above. 

Staging Steps for Zebra ET51CE Tablet Devices for model (ET51CE-G21E-00NA)

Step 1: Preparation

• Perform a power up inspection of the devices. Verify that the device loads to setup screen and touch screen is working.

• Asset tag the device.

  • Use the "ET51CE Asset Location" file. This will show where to put the asset tag. 

•  Record the serial numbers and corresponding asset tag numbers in the work order.

  • Use the "Device Capture Example" file. This will show you what the results should look like in the work order.

• Enroll the device using Google Zero-Touch Enrollment.

  • If needed, use the "ET51 ZeroTouch Enrollment Template" file. This will help setup the enrollment for the devices.

  • Use the "ET51 ZeroTouch Enrollment Guide" file. This will guide you through the enrollment process.

Step 2: OS load - Android 11 Approved Base Build 11-46-25.00-RG-U00

• With the ET51CE powered off, press and release the power button and then press and hold the volume down button. The Fastboot screen will appear after a few seconds.

  • • • • Press the Volume Up or Volume Down buttons to navigate to "Recovery Mode". Press the power button to select the "Recovery Mode" option.

• Once in recovery mode, use the volume keys to navigate through the list and highlight “Apply upgrade from SD card” and press the power button once to select. Then select the “HE_FULL_UPDATE_11-46-25.00-RG-U00-STD-HEL-04.zip” package.

• Once the device has been upgraded, select “Power off” from the boot menu. 

• Repeat the first step Step 1 to go to Android Recovery to double check that the ET51CE is now on OS 11-46-25.00-RG-U00 and then reboot the device.

Step 3: Staging

• After the reboot, select the yellow Start button on the “Hi There” welcome screen.

• Connect to appropriate Staging Network (Ex: SST Guest Access / SSTStaging) 

• The device will reach out to Google and transition between multiple pages.

  • 1. 1. 1. • Select Next on This device belongs to your organization page.

             • Device will transition from the Getting ready for work setup page to Disney's Terms and Conditions page. Click ACCEPT.

  • Select Accept & continue on the Let’s set up your device page.
    Note: Steps may not occur in the order listed.

  • Click Next on This device isn’t private page.

• The device will progress through a number of AirWatch and Google configuration screens as it proceeds through setup.

  • Install Applications screen: Allow the device to install all applications listed. Button will change from SKIP to Continue after all apps have installed. Select CONTINUE when complete.

  • Always accessible (HUB) screen: Tap GOT IT if this screen displays.

  • Google Services screen: Leave all settings turned ON, scroll to the bottom of the page and click ACCEPT.

  • Click Done on Your device is ready to go! page.

Staging is complete